1997 BUICK RIVIERA 2DR COUPE
Security
Battery RED + (+) OR RED/WHT IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 VIO + (+) IGNITION SWITCH HARNESS
AllDoorTrigger LT.BLU (-) (-) RIGHT OF GAS PEDEL
TrunkTrigger ORN/BLK (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK PANEL IN DOOR BOOT
ParkingLights BRN (+) LEFT OF BRAKE PEDEL "LIGHT MODULE"
Remote Start
Battery RED + (+) OR RED/WHT IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 PNK/WHT + (+) IGNITION SW HARNESS"ALSO 3RD ING VIO/WHT
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 VIO + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) NEXT TO STEERING COLUMN 48 PIN CONN
Tach VIO/WHT (-) (-) AT MULTI COIL PACK "PASSENGER SIDE"
SpeedSense GRN/WHT 4000 (AC) RHT REAR FIREWALL WHT 32 PIN CONN POS D1
ParkingLights BRN (+) LEFT OF BRAKE PEDEL "LIGHT MODULE"
BrakeLights WHT (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) SWITCH ON TRANSMISSION
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (+) OR GRY POSITIVE TRIGGER
PowerLock LT.BLU (+) UNDER DRIVER'S SIDE FLOOR MOLDING
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN
Convenience
HeadLights TAN (+) (+) LAMP CONTROL MODULE
HeadLightsHi GREEN (+) AT VEHICLE LIGHT SWITCH
TrunkRelease BLK (-) (-) DRIVER'S KICK PANEL, DOOR HARNESS
Mobile Audio / Video
Battery RED + (+) OR RED/WHT IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp TRUNK, ON BACK SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
