1996 TOYOTA CELICA 2DR COUPE
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLU/ORN (+) IGNITION SWITCH HARNESS
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) DRIVER'S KICK PANEL
TrunkTrigger RED/GRN (-) (-) DRIVER'S KICK HARNESS
ParkingLights GRN (+) AT DIMMER OR FUSEBOX
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLU/ORN (+) IGNITION SWITCH HARNESS
Ignition02 BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 + IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense YEL (-) (-) IGNITION SWITCH HARNESS
Tach WHT/BLU (-) (-) OR BLK (-) AT DIAG PLUG OR IGNITER
SpeedSense ORG (AC) PASS CONSOLE 22 PIN POS 9 OR 12 PIN POS1
ParkingLights GRN (+) AT DIMMER OR FUSEBOX
BrakeLights GRN/WHT (+) (+) AT BRAKE SWITCH
ReverseLights RED/WHT (+) (+) 10 PIN GRY PLUG DRIVERS KICK
Horn GRN (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock BLU/RED (-) (-) NEGATIVE TRIGGER
PowerLock BLU (-) (-) AT DOOR LOCK MOD "RT OF STEERING COLUMN"
LeftFrontWindow01 LF:GRN
RightFrontWindow01 RF:GRN/WHT LF:GRN/WHT RR:GRN
LeftRearWindow01 LF:RED
RightRearWindow01 RF:RED/BLU LF:RED/WHT RR:RED
Convenience
HeadLights RED/BLK (-) (-) AT HEADLIGHT SWITCH
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 + IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
PowerAntenna BLK/RED (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearLeftSpeakerNeg YEL
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Amp UNDER PASS . SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
