1996 PONTIAC BONNEVILLE 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL (+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) COURTESY LIGHT UNDER DASH
TrunkTrigger ORN/BLK (-) (-) AT HARNESS FROM TRUNK LID
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK OR AT RAC MOD PASS SIDE
ParkingLights BRN (+) DRIVER'S KICK PANEL
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL (+) + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSKEY
KeySense LT.GRN (-) IGNITION SWITCH HARNESS
Tach VIO/WHT (-) (-) AT MULTI COIL PACK OR AT PCM "PASS FLOOR
ParkingLights BRN (+) DRIVER'S KICK PANEL
BrakeLights LT.BLU (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+)
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock ORG/BLK (-) (-) DRIVER'S KICK PANEL
PowerLock LT.BLU (-) (-) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:BLU
RightFrontWindow01 RF:LT.BLU LR:GRN RR:LT.GRN REVERSE
LeftRearWindow01 LF:BRN/WHT
RightRearWindow01 RF:TAN LR:VIO RR:VIO/WHT POLARITY
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT WIPER SWITCH
TrunkRelease BLK (-) (-) IN DRIVER'S DOOR BOOT
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
