1996 PLYMOUTH BREEZE 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DR.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) LOCATED UNDER FUSEBOX "6 PIN CON"
TrunkTrigger TAN/BLK (-) (-) DRIVER'S KICK PANEL
FactoryAlarmDisarm LT.GRN/ORG FROM DRIVER'S DOOR
FactoryAlarmArm LT.GRN/ORG ONE WIRE ARM AND DISARM
ParkingLights BLK/YEL + (+) DRIVER'S KICK PANEL BEHIND FUSEBOX
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DR.BLU (+) IGNITION SWITCH HARNESS
Ignition02 +
Ignition03 +
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLK/GRY (-) (-) AT COIL PACK
SpeedSense WHT/ORG (AC) P66 PCM DRIVER'S FENDER NEXT TO PW DIS
ParkingLights BLK/YEL + (+) DRIVER'S KICK PANEL BEHIND FUSEBOX
BrakeLights WHT/TAN (+) AT BRAKE SWITCH
Doorlocks / Window
PowerUnLock WHT/LT.GRN (+) SINGLE WIRE SETUP "1.5 OHM TECH TIP
PowerLock WHT/LT.GRN (+) NEAR FUSEBOX "20 PIN CON"
LeftFrontWindow01 LF:LT.BLU/GLD
RightFrontWindow01 RF:BRN/WHT LR:BLU/WHT RR:GRY/BLK
LeftRearWindow01 LF:WHT/GLD
RightRearWindow01 RF:VIO/WHT LR:RED/BLK RR:GRN/WHT
Doorlocks / Windows
Power UnLock
USE 1.5KOHM RESISTOR
Convenience
HeadLights GRN (+) AT LIGHT SWITCH
TrunkRelease BLK/WHT (+) DRIVER'S KICK PANEL
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination ORG/BRN (+) RADIO HARNESS
Dimmer BLK/LT.BLU (+) RADIO HARNESS
PowerAntenna ORG/RED (+) RADIO HARNESS
FrontLeftSpeakerPos DK.GRN
FrontLeftSpeakerNeg BRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg DARK BLUE/RED
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/LT.BLU
RearRightSpeakerPos DK.BLU/WHT
RearRightSpeakerNeg DK.BLU/ORN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
