1996 MERCURY VILLAGER MINIVAN
Security
Battery WHT/VIO + (+) IGN. HARNESS
Ignition WHT/RED (+) IGN. HARNESS
Starter01 RED + (+) IGN SW HAR *RED/GRN COLD START WIRE*
AllDoorTrigger RED/WHT (-) DRIVER'S KICK OR DASH IND.(DIODE ISOLATE
TrunkTrigger LT.BRN/WHT(-) (-) DRIVER'S KICK "USE DIODE TO ISOLATE"
FactoryAlarmDisarm RED/BLK (-) DRIVERS KICK
ParkingLights PNK (+) (+) DRIVER'S KICK PANEL
Remote Start
Battery WHT/VIO + (+) IGN. HARNESS
Ignition WHT/RED (+) IGN. HARNESS
Ignition02 BRN (2ND ACC) (+) IGN. HARNESS
Ignition03 +
Accessory01 WHT/GRN + (+) IGN. HARNESS
Accessory02 +
Starter01 RED + (+) IGN SW HAR *RED/GRN COLD START WIRE*
Starter02 RED/GREEN (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/ORG (-) (-) STEERING COLUMN
Tach GRN (AC) (AC) IGN. MODULE ON ENGINE
SpeedSense PNK/BLU (AC) TRANSAX
ParkingLights PNK (+) (+) DRIVER'S KICK PANEL
BrakeLights YEL/BLK (+) (+) AT SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock GRN/ORG (-) (-) DRIVER'S KICK PANEL OR CENTER CONSOLE
PowerLock GRN/WHT (-) (-) DRIVER'S KICK PANEL OR CENTER CONSOLE
DriverDoorMotor02 MELINDA/WAYNE
LeftFrontWindow01 LF:VIO
RightFrontWindow01 RF:GRN/BLK LR:RED/WHT RR:RED
LeftRearWindow01 LF:BLU/RED
RightRearWindow01 RF:ORG/BLU LR:RED/BLK RR:RED/BLU
Convenience
HeadLights GRY/RED (+) LIGHT SWITCH
TrunkRelease N/A
Mobile Audio / Video
Mobile Audio / Video
Battery WHT/VIO + (+) IGN. HARNESS
Accessory01 WHT/GRN + (+) IGN. HARNESS
Ground BLK/LT.GRN (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
FrontLeftSpeakerPos ORG/LT.GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/LT.GRN
FrontRightSpeakerNeg DARK GREEN/ORANGE
RearLeftSpeakerPos LT.BRN/WHT
RearLeftSpeakerNeg LT.BRN/YEL
RearRightSpeakerPos LT.BRN/GRN
RearRightSpeakerNeg BRN/PNK
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
