1996 MERCURY SABLE 4DR WAGON
Security
Battery BLK/ORG + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 WHT/PNK(+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) LIGHT UNDER DASH
TrunkTrigger BRN/WHT OR (-) BLK/PNK(-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery BLK/ORG + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 GRY/YEL + (+) AND BLK/GRN IGN SW HAR "BLK/GRN FOR AC"
Accessory02 +
Starter01 WHT/PNK(+) + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem PATS
Tach TAN/YEL (-) (-) AT COIL OR GRY/ORN(-)DIS MOD PAS SIDE EN
SpeedSense DK.GRN/WHT (AC) WIRE HARN.FROM TRANSAX
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights RED/GRN (+) AT BRAKE SWITCH
Horn YEL/LT.GRN(-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN (-) W/KEYLESS NEGATIVE TRIGGER SAME LOCATION
PowerLock PNK/YEL (-) DRIVER'S KICK PANEL REVERSE POLARITY
Doorlocks / Windows
Power UnLock
(REV) ON MODELS WITHOUT KEYLESS
PowerLock
(REV) ON MODELS WITHOUT KEYLESS
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
LowSpeedWipers BLK/PNK (-) AT WIPER SWITCH
TrunkRelease PPL/YEL(+) (+) SWITCH ON DASH
Mobile Audio / Video
Battery BLK/ORG + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) AND BLK/GRN IGN SW HAR "BLK/GRN FOR AC"
Ground BLK/LT.GRN (-) RADIO HARNESS
Illumination LT.BLU/RED (+) RADIO HARNESS
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos ORN/LT.GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/LT.GRN
FrontRightSpeakerNeg DARK GREEN/ORANGE
RearLeftSpeakerPos PNK/LT.GRN
RearLeftSpeakerNeg DK.BLU/ORN
RearRightSpeakerPos PNK/LT.BLU
RearRightSpeakerNeg TAN/WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
