1996 MAZDA MILLENIA 4DR SEDAN
Security
Battery BLK/BLU + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger LT.GRN (-) (-) AT HARNESS BEHIND FUSEBOX
TrunkTrigger RED (-) (-) 16 PIN CONN REAR OF FUSE BOX POS 15
FactoryAlarmDisarm LT.GRN/RED(-) DRIVER'S KICK "ADD 1000 OHM RES INLINE"
ParkingLights ORG (+) AT FUSEBOX "GRN PLUG"
Remote Start
Battery BLK/BLU + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/YEL (+) (+) AT STEERING COLUMN HARNESS
NeutralSafety OEM SWITCH OPEN STARTER
Tach YEL (-) (-) DIST:GRN/BLU LEFT COLUMN 16 PIN CONN
SpeedSense GRN/RED (AC) REAR OF FUSEPANEL
ParkingLights ORG (+) AT FUSEBOX "GRN PLUG"
BrakeLights WHT/GRN (+) (+) AT BRAKE SWITCH
ReverseLights RED/YEL (+) AT SWITCH ON TRANS
Horn GRN/RED (-) AT SWITCH CHANGES RED/WHT
Doorlocks / Window
PowerUnLock GRN/WHT (-) (-) NEGATIVE TRIGGER
PowerLock WHT/BLU (-) (-) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:GRN
RightFrontWindow01 RF:GRN/WHT LR:BLU/WHT RR:GRN/YEL
LeftRearWindow01 LF:RED/BLU
RightRearWindow01 RF:RED/WHT LR:YEL/WHT RR:WHT/RED
Convenience
HeadLights WHT/VIO (-) (-) AT HEADLIGHT SWITCH
TrunkRelease BRN/WHT (+) (+) DRIVERS KICK PANEL
Mobile Audio / Video
Battery BLK/BLU + (+) IGNITION SWITCH HARNESS
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Ground -
FrontLeftSpeakerPos YEL
FrontLeftSpeakerNeg BLU
FrontRightSpeakerPos PNK
FrontRightSpeakerNeg VIOLET
RearLeftSpeakerPos GRN
RearLeftSpeakerNeg YEL/GRN
RearRightSpeakerPos GRN/BLK
RearRightSpeakerNeg GRN/ORG
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
