1996 HONDA CIVIC 4DR SEDAN
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AllDoorTrigger LT.GRN/RED(-) (+) ABOVE FUSE PANEL OR BEHIND RADIO GRN CON
TrunkTrigger BLU/BLK (-) (-) DRV KICK OR BEHIND RADIO"LT.GRN(-) WIRE"
ParkingLights RED/BLK (+) DRIVER'S KICK PANEL OR ABOVE FUSEBOX
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Ignition02 YEL + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 WHT/BLK + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLU (-) (-) AT COIL OR TEST PLUG"DRV SIDE FIRE WALL"
SpeedSense BLU/WHT (AC) DRIV DASH 20 PIN CONN ABOVE FUSE
ParkingLights RED/BLK (+) DRIVER'S KICK PANEL OR ABOVE FUSEBOX
BrakeLights GRN/WHT (+) AT BRAKE SWITCH
ReverseLights GRN/BLK (+) DRIVER'S KICK
Horn GRY (-) AT STEERING COLUMN OR GRN PLUG BEHIND RA
Doorlocks / Window
PowerUnLock GRN/ORG (-) (-) MOD BEHID RADIO"GRN PLUG"NEGATIVE TRIGGE
PowerLock GRN/WHT (-) (-) DRIVER'S KICK BLU PLUG OR AT ANTI-THEFT
Convenience
HeadLights RED/WHT L AND RED/BLU R AT STEERING COLUMN
LowSpeedWipers BLU/YEL (-) (-) AND BLU (-) AT STEERING COLUMN
TrunkRelease N/A
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 WHT/BLK + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination RED/BLK (+) RADIO HARNESS
FrontLeftSpeakerPos BLU
FrontLeftSpeakerNeg GRY/BLK
FrontRightSpeakerPos RED/GRN
FrontRightSpeakerNeg BROWN/BLACK
RearLeftSpeakerPos BLU/YEL
RearLeftSpeakerNeg GRY/WHT
RearRightSpeakerPos RED/YEL
RearRightSpeakerNeg BRN/WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
