1996 DODGE AVENGER 2DR COUPE
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/BLK (-) (-) DRIVER'S KICK PANEL
TrunkTrigger RED/GRN (-) (-) AT TRUNK LIGHT
ParkingLights GRN/WHT (+) LEFT OF STEERING COLUMN
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU/BLK + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense GRN/YEL (-) (-) STEERING COLUMN HARNESS
NeutralSafety BLK/YEL (-) (-) SWITCH DR. SIDE OF TRANSMISSION
Tach BRN (-) (-) AT COIL PACK(WHT/BRN DOT BOTTEM PCM PLUG
SpeedSense WHT/ORG (AC) POS 66 BLK 2-40 PIN OF PCM LEFT FRT QTR
ParkingLights GRN/WHT (+) LEFT OF STEERING COLUMN
BrakeLights GRN (+) AT BRAKE SWITCH
ReverseLights RED/BLU (+) DRIVER'S KICK PANEL
Horn GRN/BLK (-) AT STEERING COLUMN "WHT 3 PIN PLUG"
Doorlocks / Window
PowerUnLock BRN (-) (-) NEGATIVE TRIGGER
PowerLock BRN/WHT (-) (-) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:GRN/RED
RightFrontWindow01 RF:BRN/YEL MAIN
LeftRearWindow01 LF:GRN/BLK
RightRearWindow01 RF:GRN/YEL SWITCH
Convenience
HeadLights RED(-) (-) STEERING COLUMN HARNESS
LowSpeedWipers BLK/WHT (+) AT STEERING COLUMN
TrunkRelease N/A
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLU/BLK + (+) IGNITION SWITCH HARNESS
Ground BLK/YEL - (-) RADIO HARNESS
Dimmer GRN/YEL (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLU
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/RED
RearLeftSpeakerPos YEL/BLU
RearLeftSpeakerNeg GRY/BLU
RearRightSpeakerPos YEL/RED
RearRightSpeakerNeg GRY/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
