1996 CHRYSLER SEBRING 2DR CONVERTIBLE
Security
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/GRN (-) (-) BOTTOM OF FUSEBOX
TrunkTrigger TAN/BLK (-) (-) DRIVER'S KICK PANEL
FactoryAlarmDisarm LT GRN/ORG + AT BACK OF FUSE PANEL.
ParkingLights BLK/YEL (+) REAR OF FUSEBOX
Remote Start
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORG + (+) IGNITION HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.BLU (-) IGNITION SWITCH HARNESS
NeutralSafety BLK/L.BLU (-) (-) AT SWITCH ON TRANSMISSION
Tach BRN/GRN (AC) AT ECM UNDER AIR CLEANER FRONT CONN.1 CY
SpeedSense WHT/ORG 8000 (AC) DRIV FRT FENDER 60 PIN PLUG POS 58
ParkingLights BLK/YEL (+) REAR OF FUSEBOX
BrakeLights WHT/TAN (+) BACK OF FUSE PANEL.
ReverseLights VIO/BLK (+) (+) 16 PIN GRN PLG LEFT OF STEERING COLUMN
Horn BLK/RED (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT/LT.GRN (+) SINGLE WIRE SETUP "SEE TECH TIP"
PowerLock WHT/LT.GRN (+) NEAR FUSEBOX
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:BRN/WHT LR:BLU/WHT RR:GRY/BLK
LeftRearWindow01 LF:DK.GRN
RightRearWindow01 RF:VIO LR:ORG RR:BRN
Doorlocks / Windows
Power UnLock
USE 2.7KOHM RESISTOR
PowerLock
USE 620 OHM RESISTOR
Convenience
HeadLights VIO/WHT LO (+) RED/ORG (HI) AT HEADLIGHT SWITCH
TrunkRelease GRN/BLK (+) DRIVER'S KICK OR AT SWITCH
Mobile Audio / Video
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION HARNESS
Ground BLK/YEL - (-) RADIO HARNESS
Dimmer GRN/YEL (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLU
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/RED
RearLeftSpeakerPos YEL/BLU
RearLeftSpeakerNeg GRY/BLU
RearRightSpeakerPos YEL/RED
RearRightSpeakerNeg GRY/RED
Amp IN TRUNCK,LEFT PANEL
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
