1996 BUICK SKYLARK 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRN/BLK(-) L (+) DRV KICK, LT.BLU(-) R PASS KICK"ISOLATE"
TrunkTrigger ORG/BLK (-) LIGHT IN TRUNK
ParkingLights BRN (+) (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 WHT + (+) IGN SW "MUST ENERGIZE TO REMOTE START"
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety ORG/BLK(-) (-) SWITCH ON TRANSAXLE
Tach WHT (-) PASS DASH BLUE 80 PIN CONN POS 53 OR COI
SpeedSense GRN/WHT (AC) PASS DASH BLU 80 PIN CONN POS 13
ParkingLights BRN (+) (+) AT LIGHT SWITCH
BrakeLights WHT (-) (+) AT BRAKE SWITCH
ReverseLights LT GRN(+) (+) SWITCH ON TRANSAXLE
Horn BLK(-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT (+) (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) (+) DRIVER'S KICK PANEL
Convenience
HeadLights TAN(LO)GRN(HI (+) (+)HEADLIGHT SWITCH
HeadLightsHi GREEN (+) AT VEHICLE LIGHT SWITCH
TrunkRelease BLK (-) TRUNL RELEASE
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
LEFT OF STEERING COLUMN
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
