1995 JAGUAR XJ12 4DR SEDAN
Security
Battery BRN (+) + (+) HARNESS FROM UNDER HOOD FIREWALL DR. SID
Ignition WHT/ORG (-) (+) NEGATIVE WIRE IGNITION HARNESS
Starter01 RED/WHT (-) + (-) NEGATIVE WIRE IGNITION HARNESS
AllDoorTrigger VIO (-) (+) AND VIO/RED DIO ISOLATE AT EITHER KICK
TrunkTrigger RED/YEL (-) (-) FACTORY ALARM MODULE IN TRUNK
HoodTrigger BLU/WHT(-) (-) FACTORY ALARM MODULE OR LOW PASS KICK
FactoryAlarmDisarm W/LOCKS
FactoryAlarmArm W/LOCKS
ParkingLights BLU/LT GRN(-) (+) AT SWITCH OR YEL/RED HAZARD SWITCH
Remote Start
Battery BRN (+) + (+) HARNESS FROM UNDER HOOD FIREWALL DR. SID
Ignition WHT/ORG (-) (+) NEGATIVE WIRE IGNITION HARNESS
Ignition02 BLU/RED (-) + (-) NEGATIVE WIRE IGNITION HARNESS
Ignition03 +
Accessory01 WHT/BRN (-) + (-) NEGATIVE WIRE IGNITION HARNESS
Accessory02 +
Starter01 RED/WHT (-) + (-) NEGATIVE WIRE IGNITION HARNESS
AntiTheftSystem NONE
Tach VIO/YEL (-) ECM UPPER PASS KICK PANEL
ParkingLights BLU/LT GRN(-) (+) AT SWITCH OR YEL/RED HAZARD SWITCH
BrakeLights VIO/BLU (-) (+) SWITCH ABOVE BRAKE PEDAL
Horn GRN/BLU (-) STEERING COLUMN
Doorlocks / Window
PowerUnLock ORG/BLU (-) (-) OR SEC. MODULE FRONT LEFT SIDE OF TRUNK
PowerLock ORG/YEL (-) (-) DR. KICK PANEL (NEGATIVE TRIGGER)
LeftFrontWindow01 LF: BLU
RightFrontWindow01 RF: BLU LR:BLU RR:BLU EACH DOOR
LeftRearWindow01 LF:ORG
RightRearWindow01 RF:ORG LR:ORG RR:ORG EACH DOOR
Convenience
HeadLights ORG/LT.GRN(-) (-) LIGHT SWITCH
TrunkRelease VIO/WHT(-) (-) FACTORY ALARM MODULE IN TRUNK
Mobile Audio / Video
Battery BRN (+) + (+) HARNESS FROM UNDER HOOD FIREWALL DR. SID
Accessory01 WHT/BRN (-) + (-) NEGATIVE WIRE IGNITION HARNESS
Ground -
Amp BEHIND GLOVEBOX
Control Modules
FRONT LEFT SIDE OF TRUNK
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
