1995 DODGE NEON 4DR SEDAN
Security
Battery PNK/BLK + (+) OR RED IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (+) PIN SWITCH OR GRY 16 PIN CONN DR.DASH
TrunkTrigger GRY/BLK (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BLK/YEL (+) (+) SWITCH OR BLK 8 PIN CONN DR. KICK PANEL
Remote Start
Battery PNK/BLK + (+) OR RED IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 RED/WHT + REMOTE START BCM (CHECK ENG LIGHT)
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS(HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.BLU (-) (-) HEADLIGHT SWITCH
NeutralSafety BRN/YEL (-) (-) BLK 40 PIN CONN AT PCM FRT DR. STRUT
Tach GRY/LT.BLU (-) BLK 40 PIN CONN AT PCM FRT DR. STRUT
SpeedSense WHT/ORG (AC) PCM,DRIVERS FEND.60 OR 2-40 PIN PLUG
ParkingLights BLK/YEL (+) (+) SWITCH OR BLK 8 PIN CONN DR. KICK PANEL
BrakeLights WHT/TAN (+) (+) AT BRAKE SWITCH
ReverseLights VIO/BLK (+) (+) SWITCH ON TRANSMISSION
Horn BLK/RED (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock ORNG/VLT (REV) REVERSE POLARITY
PowerLock PNK/VLT (REV) BLU 16 PIN CONN DRIVERS KICK PANEL
LeftFrontWindow01 LF:WHT
RightFrontWindow01 RF:VIO/WHT
LeftRearWindow01 LF:LT.BLU
RightRearWindow01 RF:BRN/WHT
Convenience
HeadLights LT.GRN (+) (+) AT LIGHT SWITCH
LowSpeedWipers GRN/YEL (-) AND RED/YEL AT WIPER SWITCH "USE DIODE"
Mobile Audio / Video
Battery PNK/BLK + (+) OR RED IGNITION SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS(HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination ORG (+) RADIO HARNESS
Dimmer BLK/YEL (+) RADIO HARNESS
FrontLeftSpeakerPos DK.GRN
FrontLeftSpeakerNeg BRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg DARK BLUE/RED
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/LT.BLU
RearRightSpeakerPos DK.BLU/WHT
RearRightSpeakerNeg DK.BLU/ORG
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
