1995 CADILLAC SEVILLE 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 VIO + (+) IGNITION SWITCH HARNESS
AllDoorTrigger DR.BLU (-) (-) DRIVER'S KICK PANEL
HoodTrigger N/A
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGN. HARNESS
Ignition03 LT.BLU + IGNITION SWITCH POWER HEAT/A.C CONTROLS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 VIO + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-)
NeutralSafety ORG/BLK (-) AT ENGINE CONTROL MODULE
Tach VIO/WHT (-) (-) AT MULTI COIL PACK
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights WHT (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) SWITCH ON TRANS.
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:LT.BLU LR:GRN RR:LT.GRN
(DRIVERS)
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN LR:VIO RR:VIO/WHT
(SWITCH)
Convenience
TrunkRelease BLK (-) (-) TRUNK RELEASE SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp TRUNK, ON BACK SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
