1995 BUICK REGAL 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL (+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger DK.BLU (-) (-) DRIVER'S KICK PANEL OR AT COURTESY LIGHT
TrunkTrigger GRY (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK PANEL
ParkingLights BRN (+) (+) LIGHT SWITCH HARNESS
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BLU/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL (+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety ORG/BLK (-) AT ENGINE CONTROL MODULE
Tach VIO/WHT (-) (-) AT MULTI COIL PACK
SpeedSense DK.GRN (AC) PASS STRUT TOWER GRY 32 PIN CONN PIN 28
ParkingLights BRN (+) (+) LIGHT SWITCH HARNESS
BrakeLights WHT (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) AT GEAR SELECT SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock ORG/BLK (-) (-) KEYLESS MODULE NEXT TO STEERING COLUMN
PowerLock RED/BLK (-) (-) KEYLESS MODULE NEXT TO STEERING COLUMN
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
TrunkRelease BLK (+) (+) AT SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Ground BLK/WHT - (-) RADIO HARNESS
Illumination GRY/BLK (+) RADIO HARNESS
Dimmer BRN/WHT (+) RADIO HARNESS
PowerAntenna DK.GRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp UNDER GLOVEBOX
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
