1994 SATURN SC2 2DR COUPE
Security
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) (-) BEHIND FUSEBOX UNDER CONSOLE
TrunkTrigger LT.GRN (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) (+) AT STEERING COLUMN OR BEHIND FUSEBOX
Remote Start
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGNITION SWITCH HARNESS "2ND ACC
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) STEERING COLUMN
Tach WHT (-) (-) OR VIO/WHT (-) AT COIL OR MULTI COIL PAC
SpeedSense GRN (AC) ABOVE PEDAL OR BLU 32 PIN CONN POS D-6
ParkingLights BRN (+) (+) AT STEERING COLUMN OR BEHIND FUSEBOX
BrakeLights LT.BLU (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+)
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLK (-) (-) NEGATIVE TRIGGER
PowerLock LT.BLU (-) (-) BEHIND FUSEBOX UNDER CONSOLE OR DRV KICK
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:BLU/WHT, AT SWITCH
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN, AT SWITCH
Convenience
HeadLights TAN (+) AT LIGHT SWITCH
Mobile Audio / Video
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
