1994 MERCURY VILLAGER MINIVAN
Security
Battery WHT/VIO + (+) IGNITION SWITCH HARNESS
Ignition WHT/RED (+) IGNITION SWITCH HARNESS
Starter01 RED + (+) ALSO COLD START WIRE RED/GRN
AllDoorTrigger RED/WHT (-) (-) DRIVER'S KICK PANEL
TrunkTrigger LT.BRN/WHT(-) (-) DRIVER'S KICK "USE DIODE TO ISOLATE"
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights PNK (+) DRIVER'S KICK PANEL
Remote Start
Battery WHT/VIO + (+) IGNITION SWITCH HARNESS
Ignition WHT/RED (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGN SW HAR"THIS IS A 2ND ACCESSORY WIRE"
Ignition03 +
Accessory01 WHT/GRN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED + (+) ALSO COLD START WIRE RED/GRN
Starter02 RED/GREEN (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/ORG (-) STEERING COLUMN
Tach GRN (-) (-) AT COIL
SpeedSense PNK/BLU (AC) TRANSAX
ParkingLights PNK (+) DRIVER'S KICK PANEL
BrakeLights YEL/BLK (+) AT BRAKE SWITCH
ReverseLights BLU/RED (+) (+) SWITCH TOP FRONT OF TRANSAXLE
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock GRN/ORN (-) (-) BEHIND CASSETTE COMP NEGATIVE TRIGGER
PowerLock GRN/WHT (-) (-) DRV KICK OR CONSOLE LOOSE WHT 3 PIN PLUG
LeftFrontWindow01 LF=BLU/PNK
RightFrontWindow01 RF=GRN/BLK, AT SWITCH
LeftRearWindow01 LF=BLU/GRN
RightRearWindow01 RF=ORG/BLK, AT SWITCH
Convenience
HeadLights GRY/RED (+) LIGHT SWITCH
TrunkRelease BRN/WHT (-) (-) DRIVERS KICK PANEL
Mobile Audio / Video
Battery WHT/VIO + (+) IGNITION SWITCH HARNESS
Accessory01 WHT/GRN + (+) IGNITION SWITCH HARNESS
Ground FOR -
Illumination INFO
FrontLeftSpeakerPos FOR
FrontLeftSpeakerNeg INFO
FrontRightSpeakerPos SEE
RearLeftSpeakerPos FOR
RearLeftSpeakerNeg INFO
RearRightSpeakerPos SEE
RearRightSpeakerNeg TECH TIP
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
