1994 MAZDA MX3 2DR COUPE
Security
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Starter01 BLK/BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) AT FUSEBOX "3 PIN PLUG"
TrunkTrigger RED (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights RED/BLK (+) AT DIMMER CONTROL SWITCH
Remote Start
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/BLU + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach YEL/BLU (-) (-) AT DISTRIBUTOR
SpeedSense VIO/RED (AC) PASS CONSOLE 22 PIN CONN ECM POS 5
ParkingLights RED/BLK (+) AT DIMMER CONTROL SWITCH
BrakeLights GRN (+) AT BRAKE SWITCH
Horn GRN/BLK (-) OR GRN/RED (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock N/A ADD ACTUATOR IN DRIVER'S DOOR
PowerLock N/A ADD ACTUATOR IN DRIVER'S DOOR
LeftFrontWindow01 LF=RED/BLK
RightFrontWindow01 RF=GRN/WHT
LeftRearWindow01 LF=RED/GRN
RightRearWindow01 RF=RED/WHT
Doorlocks / Windows
Power UnLock
ADD AN ACTUATOR
PowerLock
ADD AN ACTUATOR
Convenience
HeadLights BLU/YEL (-) (-) AT STEERING COLUMN
LowSpeedWipers BLU/WHT (+) AT STEERING COLUMN
Mobile Audio / Video
Battery BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination RED/BLK (+) RADIO HARNESS
Dimmer N/A
FrontLeftSpeakerPos BLU
FrontLeftSpeakerNeg BLU/WHT
FrontRightSpeakerPos BLU/RED
FrontRightSpeakerNeg BLUE/YELLOW
RearLeftSpeakerPos BLU/WHT
RearLeftSpeakerNeg BLU/GRN
RearRightSpeakerPos BLU/RED
RearRightSpeakerNeg BLU/GRN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
