1994 JEEP CHEROKEE 2DR SUV
Security
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Ignition BLU/WHT (+) IGNITION SWITCH HARNESS
Starter01 YEL/BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) AT UNDER DASH LIGHT
TrunkTrigger N/A WORKS WITH DOME LIGHT
HoodTrigger N/A
FactoryAlarmDisarm VIO/YEL (-) DRIVER'S KICK PANEL
ParkingLights BLU/RED (+) DRIVER'S KICK PANEL "BLK PLUG"
Remote Start
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Ignition BLU/WHT (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL/BLU + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLK/GRY (-) (-) OR BLK/WHT (-) AT COIL
SpeedSense WHT/ORN (AC) IN WIRE HARNESS FROM TRANSMISSION
ParkingLights BLU/RED (+) DRIVER'S KICK PANEL "BLK PLUG"
BrakeLights WHT (+) AT BRAKE SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/VIO (+) POSITIVE TRIGGER
PowerLock ORN/VIO (+) DRIVER'S KICK PANEL "GRY PLUG"
LeftFrontWindow01 LF-WHT
RightFrontWindow01 RF=BRN/WHT
Convenience
HeadLights BRN/BLK (+) LEFT OF STEERING COLUMN
LowSpeedWipers YEL (+) AT BLK BOX UNDER DASH
Mobile Audio / Video
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination LT.BLU/RED (+) RADIO HARNESS
Dimmer ORG (+) RADIO HARNESS
PowerAntenna VIO/ORG (+) RADIO HARNESS
FrontLeftSpeakerPos DK.GRN
FrontLeftSpeakerNeg BRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg DARK BLUE/RED
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/LT.BLU
RearRightSpeakerPos DK.BLU/WHT
RearRightSpeakerNeg DK.BLU/ORN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
