1994 JAGUAR XJS 2DR COUPE
Security
Battery BRN + (+) IGNITION SWITCH HARNESS
Ignition WHT (+) IGNITION SWITCH HARNESS
Starter01 WHT/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/VIO (-) PASSENGERS SIDE PIN SWITCH
TrunkTrigger RED/GRY (-) (-) LIGHT SWITCH IN TRUNK
HoodTrigger BLU/WHT (-) SECURITY MODULE IN TRUNK
FactoryAlarmDisarm W/LOCKS
FactoryAlarmArm W/LOCKS
ParkingLights RED/BLU (+) (+) DIMMER CONTROL SWITCH
Remote Start
Battery BRN + (+) IGNITION SWITCH HARNESS
Ignition WHT (+) IGNITION SWITCH HARNESS
Ignition02 +
Ignition03 +
Accessory01 WHT/PNK + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 WHT/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BLK/GRN (-) (-) DR. SIDE OF GEAR BOX ON TRANS.
Tach GRY/BLU (AC) OR WHT/BRN COIL ON ENGINE
ParkingLights RED/BLU (+) (+) DIMMER CONTROL SWITCH
BrakeLights GRN/BLK (-) (-) AT SWITCH ABOVE BRAKE PEDAL
ReverseLights L GRN (+) DR. SIDE OF GEAR BOX ON TRANS.
Horn PPL/BLK (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock ORG/RED (-) (-) NEGATIVE TRIGGER
PowerLock ORG/BLU (-) (-) MODULE IN PASS KICK PANEL
LeftFrontWindow01 LF:GRN/BLU
RightFrontWindow01 RF:GRN/RED
LeftRearWindow01 LF:GRN/BLU
RightRearWindow01 RF:RED/GRN
Convenience
HeadLights BRN/BLK (-) (-) AT HEADLIGHT SWITCH
TrunkRelease VIO/WHT SECURITY MODULE
Mobile Audio / Video
Battery BRN + (+) IGNITION SWITCH HARNESS
Accessory01 WHT/PNK + (+) IGNITION SWITCH HARNESS
Ground BLACK - (-) RADIO HARNESS
Illumination N/A
Dimmer N/A
PowerAntenna GREEN (+) RADIO HARNESS
FrontLeftSpeakerPos RED/WHT
FrontLeftSpeakerNeg RED/GRN
FrontRightSpeakerPos PNK/WHT
FrontRightSpeakerNeg PINK/GREEN
RearLeftSpeakerPos RED/BRN
RearLeftSpeakerNeg RED/GRN
RearRightSpeakerPos PNK/YEL
RearRightSpeakerNeg PNK/GRN
Control Modules
LEFT SIDE OF TRUNK
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
