1994 CHEVROLET CAMARO 2DR CONVERTIBLE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRY/BLK (-) (-) DRIVER'S KICK PANEL
TrunkTrigger GRY (-) (-) BEHIND LEFT REAR SPEAKER
HoodTrigger N/A
ParkingLights BRN (+) (+) DRIVER'S KICK PANEL
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSKEY
Tach WHT (-) V6 (-) OR WHT/BLK (-) V8 AT COIL OR DISTRIBUTOR
SpeedSense GRN/WHT (AC) AIR CLEANER OR PASS STRUT BLK 32 POS 28
ParkingLights BRN (+) (+) DRIVER'S KICK PANEL
BrakeLights YEL (+) AT BRAKE SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock ORG/BLK (REV) PASSENGER SWITCH IS MASTER SWITCH
PowerLock RED/BLK (REV) DRIVER'S KICK PANEL REVERSE POLARITY
LeftFrontWindow01 R-LT BLU
RightFrontWindow01 L-DK BLU AT SWITCH
LeftRearWindow01 R-TAN
RightRearWindow01 L-BRN AT SWITCH
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers GRN (+) AT STEERING COLUMN "BLK PLUG"
TrunkRelease BLK (+) (+) SWITCH OR DRIVER'S KICK PANEL
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp REAR LEFT CARGO BAY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
