1993 TOYOTA MR2 2DR COUPE
Security
Battery BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Starter01 RED + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) DRIVER'S KICK PANEL
TrunkTrigger RED/GRN (-) (-) AT THEFT MOD "LOCATED PASS B PILLAR TRIM
HoodTrigger N/A WORKS WITH TRUNK PIN
FactoryAlarmDisarm BLK/YEL (-) DRIVERS KICK PANEL
ParkingLights GRN (+) DRIVER'S KICK PANEL
Remote Start
Battery BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Ignition02 BLK/ORN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU (-) (-) STEERING COLUMN HARNESS
Tach BLK/WHT (-) (-) AT TEST CONN"LT FRONT CORNER ENGINE COMP
ParkingLights GRN (+) DRIVER'S KICK PANEL
BrakeLights GRN/WHT (+) AT BRAKE SWITCH
Horn GRN/BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLK/YEL (-) (-) NEGATIVE TRIGGER "SEE TECH TIP"
PowerLock BLK (-) (-) PASSENGER KICK PANEL
LeftFrontWindow01 LF:GRN
RightFrontWindow01 RF:RED/BLU
LeftRearWindow01 LF:RED
RightRearWindow01 RF:GRN
Convenience
HeadLights RED (-) (-) AT STEERING COLUMN
LowSpeedWipers BLU/BLK (-) AT WIPER SWITCH
TrunkRelease N/A
Mobile Audio / Video
Battery BLK/RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLU/RED + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
PowerAntenna BLK/RED (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearLeftSpeakerNeg YEL
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Amp UNDER PASS SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
