1993 MAZDA 626 4DR SEDAN
Security
Battery BLK/BLU + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) AT FUSEBOX
TrunkTrigger RED (-) (-) AT ANTI-THEFT MOD LOCATED IN FUSEBOX
HoodTrigger BRN/WHT (-) (-) AT ANTI-THEFT MOD LOCATED IN FUSEBOX
FactoryAlarmDisarm YEL/RED (-) HARNESS FROM DOOR OR ANTI-THEFT MODULE
ParkingLights ORG (+) (+) AT DIMMER OR FUSEBOX
Remote Start
Battery BLK/BLU + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach YEL (-) (-) AT COIL OR IG- PIN AT DIAG. CONNECTOR.
SpeedSense GRN/RED 22 PIN CONN ON ECM BEHIND ASH TRAY
ParkingLights ORG (+) (+) AT DIMMER OR FUSEBOX
BrakeLights WHT/GRN (+) AT BRAKE SWITCH
Horn GRN/ORN (-) AT STEERING COLUMN OR ANTI-THEFT MOD
Doorlocks / Window
PowerUnLock N/A ADD ACTUATOR IN DRIVER'S DOOR
PowerLock N/A ADD ACTUATOR IN DRIVER'S DOOR
LeftFrontWindow01 LF-GRN/BLU/SI
RightFrontWindow01 RF-GRN/WHT
LeftRearWindow01 LF-RED/BLU/SI
RightRearWindow01 RF-WHT/YEL
Doorlocks / Windows
Power UnLock
ADD AN ACTUATOR
PowerLock
ADD AN ACTUATOR
Convenience
HeadLights RED/BLK (+) AT LIGHT SWITCH
Mobile Audio / Video
Battery BLK/BLU + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination RED/BLK (+) RADIO HARNESS
Dimmer N/A
FrontLeftSpeakerPos BLU
FrontLeftSpeakerNeg BLU/WHT
FrontRightSpeakerPos BLU/RED
FrontRightSpeakerNeg BLUE/YELLOW
RearLeftSpeakerPos BLU/RED
RearLeftSpeakerNeg BLU/GRN
RearRightSpeakerPos BLU/WHT
RearRightSpeakerNeg BLU/GRN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
