1992 CHEVROLET CAMARO 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) (-) DRIVER'S PIN SWITCH
TrunkTrigger BLK/ORN (-) (-) AT CARGO LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH OR ABOVE DRIVER'S KICK
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT GRN (-) (-) IGNITION KEY WARNING SWITCH
NeutralSafety ORN/BLK (-) AT GEAR SELECT SWITCH
Tach AT COIL OR VIO/WHT (-)"V6" AT COIL
SpeedSense GRN (AC) ECM,PASS.SIDE DASH,BLK24 PIN PLUG,PINB11
ParkingLights BRN (+) AT LIGHT SWITCH OR ABOVE DRIVER'S KICK
BrakeLights WHT (+) OR LT.BLU AT BRAKE SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLK (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK PANEL
LeftFrontWindow01 R=LT BLU
RightFrontWindow01 L=DK BLU, AT SWITCH
LeftRearWindow01 R=TAN
RightRearWindow01 L=BRN, AT SWITCH
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT WIPER SWITCH
TrunkRelease BLK (+) AT SWITCH OR DRIVER'S KICK PANEL
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
