1992 CADILLAC ELDORADO 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 VIO + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) (-) DRIVER'S KICK PANEL OR PIN SWITCH
TrunkTrigger BLK/ORG (-) (-) TRUNK LIGHT
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BLU/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 VIO + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety ORG/BLK (-) AT ENGINE CONTROL MODULE
Tach WHT (-) (-) AT DISTRIBUTOR "OR PLUG INTO TACH CONN"
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights WHT (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) AT GEAR SELECT SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLK (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK PANEL AT DOOR HARNESS
LeftFrontWindow01 LF=BRN
RightFrontWindow01 RF=BLU/WHT, AT SWITCH
LeftRearWindow01 LF=D.BLU
RightRearWindow01 RF=TAN, AT SWITCH
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
TrunkRelease BLK (+) AT SWITCH OR DRIVER'S KICK PANEL
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
