1992 BUICK CENTURY 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) (-) AT UNDER DASH LIGHT
TrunkTrigger GRY (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 ORG + (+) IGNITION SWITCH HARNESS (HEAT A/C)
Ignition03 DK.GRN + IGNITION SWITCH HARNESS BCM+PCM
Accessory01 BRN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) STEERING COLUMN HARNESS
NeutralSafety ORG/BLK (-)
Tach VIO/WHT (AC) (-) AT MULTI COIL PACK
SpeedSense GRN (AC) ECM,PASS.SIDE DASH,PNK 32PIN PLUG,PIN D1
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights WHT (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+) SWITCH ON TOP OF TRANSAXLE
Horn DK.GRN (-) AT HORN RELAY
Doorlocks / Window
PowerUnLock BLK (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK PANEL AT DOOR HARNESS
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:DK.BLU LR:DK.GRN RR:LT.GRN
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN/WHT LR:VIO RR:VIO
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
TrunkRelease BLK (+) AT SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BRN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
