1992 BMW 318I 4DR SEDAN
Security
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Ignition GRN (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/RED (-) (-) DRIVER'S REAR SIDE PILLAR "UNDER SEAT"
TrunkTrigger BRN/RED (-) (-) DRIVER'S REAR SIDE PILLAR "UNDER SEAT"
HoodTrigger VIO/GRN (-) (-) AT PIN SW UNDER HOOD
FactoryAlarmDisarm N/A
ParkingLights GRY/VIO L (+) GRY/YEL R AT LIGHT SWITCH
Security
Parking Lights
ALSO (+) GRAY/YELLOW-DIODE ISOLATE
Remote Start
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Ignition GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 VIO/WHT + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BRN/GRN (-) (-) STEERING COLUMN
Tach BLK (-) (-) AT WHT PLUG BEHIND DASH "DON'T UNPLUG"
SpeedSense BRN/RED (AC) REAR AXLE
ParkingLights GRY/VIO L (+) GRY/YEL R AT LIGHT SWITCH
BrakeLights BLU/RED (+) AT BRAKE SWITCH
Horn BRN/RED (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLU/GRY (REV) DO NOT UNPLUG DOOR LOCK MODULE
PowerLock WHT (REV) BEHIND GLOVE BOX "REVERSE POLARITY"
LeftFrontWindow01 LF:VIO
RightFrontWindow01 RF:VIO/GRY
LeftRearWindow01 LF:BLK
RightRearWindow01 RF:BLK/GRY
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
Mobile Audio / Video
Battery RED/WHT + (+) IGNITION SWITCH HARNESS
Accessory01 VIO/WHT + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
PowerAntenna WHT (+) RADIO HARNESS
FrontLeftSpeakerPos YEL/RED
FrontLeftSpeakerNeg YEL/BRN
FrontRightSpeakerPos BLU/RED
FrontRightSpeakerNeg BLUE/BLACK
RearLeftSpeakerPos YEL/SLV
RearLeftSpeakerNeg YEL/VIO
RearRightSpeakerPos BLU/RED
RearRightSpeakerNeg BLU/SLV
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
