1991 MERCURY SABLE 4DR SEDAN
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 WHT/PNK(+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) DRIVER'S KICK PANEL
TrunkTrigger BLK/PNK(-) (-) LIGHT IN TRUNK
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 GRY/YEL + (+) IGN SW HAR "ALSO BLK/GRN FOR HEATER"
Accessory02 +
Starter01 WHT/PNK(+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach TAN/YEL (-) (-) AT COIL OR GRY/ORN(-)DIS MOD PAS SIDE EN
SpeedSense GRY/BLK (AC) WIRE HARNESS FROM TRANSMISSION OR GRN/WH
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights RED/GRN (+) AT BRAKE SWITCH
Horn YEL/LT.GRN(-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN (-) W/KEYLESS NEGATIVE TRIGGER SAME LOCATION
PowerLock PNK/YEL (-) DRIVER'S KICK PANEL REVERSE POLARITY
LeftFrontWindow01 LF=WHT/BLK
RightFrontWindow01 RF=WHT/YEL, AT SWITCH
LeftRearWindow01 LF=YEL/RED
RightRearWindow01 RF=TAN/BLK, AT SWITCH
Doorlocks / Windows
Power UnLock
(REV) ON MODELS WITHOUT KEYLESS
PowerLock
(REV) ON MODELS WITHOUT KEYLESS
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
LowSpeedWipers BLK/PNK (-) AT WIPER SWITCH
TrunkRelease PPL/YEL(+) (+) RELEASE SWITCH IN DASH
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) IGN SW HAR "ALSO BLK/GRN FOR HEATER"
Ground RED OR BLK (-) RADIO HARNESS
Illumination BLU/RED (+) RADIO HARNESS
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos ORN/GRN
FrontLeftSpeakerNeg BLU/WHT
FrontRightSpeakerPos WHT/GRN
FrontRightSpeakerNeg GREEN/RED
RearLeftSpeakerPos PNK/GRN
RearLeftSpeakerNeg BLU/ORN
RearRightSpeakerPos PNK/BLU
RearRightSpeakerNeg BRN/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
