1991 BMW 318I 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition GRN (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/VIO (-) (-) DRIVER'S KICK PANEL AT DOME DELAY RELAY
TrunkTrigger BRN/BLK (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights GRY/YEL L (+) GRY/WHT R AT LIGHT SWITCH
Security
Parking Lights
ALSO (+) GRAY/WHITE-DIODE ISOLATE
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 VIO + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BRN/GRN (-) (-) STEERING COLUMN
Tach BLK (-) (-) AT DIAGNOSTIC CONNECTOR
SpeedSense BRN/RED (AC) REAR AXLE
ParkingLights GRY/YEL L (+) GRY/WHT R AT LIGHT SWITCH
BrakeLights GRN/RED (+) AT BRAKE SWITCH
ReverseLights BLU/WHT (+) AT REVERSE LIGHT SWITCH
Horn BRN/YEL (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock GRN/BLU (-) (-) NEGATIVE TRIGGER
PowerLock YEL/BLU (-) (-) DRIVER'S KICK SPK "KEEP RELAYS UPRIGHT"
LeftFrontWindow01 LF:VIO
RightFrontWindow01 RF:VIO/GRY
LeftRearWindow01 LF:BLK
RightRearWindow01 RF:BLK/GRY
Convenience
HeadLights YEL/GRN (-) (-) AT LIGHT SWITCH
LowSpeedWipers BLK/RED (-) (-) AT WIPER SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 VIO + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
FrontLeftSpeakerPos WHT
FrontLeftSpeakerNeg BLK
FrontRightSpeakerPos WHT
FrontRightSpeakerNeg BLACK
RearLeftSpeakerPos WHT
RearLeftSpeakerNeg BLK
RearRightSpeakerPos WHT
RearRightSpeakerNeg BLK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
