1990 TOYOTA CAMRY 4DR SEDAN
Security
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/ORG (+) IGNITION SWITCH HARNESS
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) DRIVER'S KICK PANEL
TrunkTrigger RED/WHT (-) (-) AT TRUNK LIGHT WGN MODEL WORKS W/DOME LH
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights DK.GRN (+) AT FUSEBOX
Remote Start
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/ORG (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLK (-) (-) AT IGNITER BY COIL OR DIGN PLUG
SpeedSense VIO/YEL 3.0L (AC) CENTER CON AT ECM 22 PIN 4000 PULSE
ParkingLights DK.GRN (+) AT FUSEBOX
BrakeLights GRN/WHT (+) AT BRAKE SWITCH
Horn GRN/BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock GRN/RED (-) (-) NEGATIVE TRIGGER
PowerLock LT.GRN (-) (-) DRIVER'S KICK PANEL "SEE TECH TIP"
LeftFrontWindow01 RED/BLU
RightFrontWindow01 AT SWITCH
LeftRearWindow01 DK GRN/BRN
RightRearWindow01 AT SWITCH
Convenience
HeadLights RED/GRN (-) (-) AT STEERING COLUMN
LowSpeedWipers BLU/ORN (-) AT STEERING COLUMN
TrunkRelease N/A
Mobile Audio / Video
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
PowerAntenna BLK/RED (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearLeftSpeakerNeg YEL
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Amp BEHIND GLOVEBOX
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
