1989 MAZDA RX-7 2DR CONVERTIBLE
Security
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLU/WHT (-) (-) AT CPU DRIVER'S UNDERDASH NEAR KICK PANE
TrunkTrigger GRY (-) (-) AT CPU DRIVER'S UNDERDASH NEAR KICK PANE
HoodTrigger BRN/WHT (-) (-) AT CPU DRIVER'S UNDERDASH NEAR KICK PANE
FactoryAlarmDisarm LT.GRN/BLK(-) DRIVER'S KICK OR CPU
ParkingLights RED/BLK (+) AT LIGHT SWITCH OR FUSEBOX
Remote Start
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/BLU + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach YEL/BLU (-) (-) AT REAR COIL "BLK PLUG"
SpeedSense GRN/RED (AC) RIGHT SIDE DASH,16 PIN PLUG
ParkingLights RED/BLK (+) AT LIGHT SWITCH OR FUSEBOX
BrakeLights GRN (+) AT BRAKE SWITCH
ReverseLights RED (+) AT DRIVER'S KICK
Horn GRN/ORN (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock N/A ADD ACTUATOR IN DRIVER'S DOOR
PowerLock N/A ADD ACTUATOR IN DRIVER'S DOOR
Doorlocks / Windows
Power UnLock
ADD AN ACTUATOR
PowerLock
ADD AN ACTUATOR
Convenience
HeadLights RED/WHT (-) (-) AT LIGHT SWITCH
Mobile Audio / Video
Battery BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination RED/BLK (+) RADIO HARNESS
Dimmer N/A
FrontLeftSpeakerPos BLU
FrontLeftSpeakerNeg BLU/WHT
FrontRightSpeakerPos BLU/RED
FrontRightSpeakerNeg BLUE/YELLOW
RearLeftSpeakerPos BLU/WHT
RearLeftSpeakerNeg BLU/GRN
RearRightSpeakerPos BLU/RED
RearRightSpeakerNeg BLU/GRN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
