1989 CHRYSLER LEBARON 2DR CONVERTIBLE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) DRIVER'S KICK PANEL
TrunkTrigger TAN/BLK (-) (-) DRIVER'S KICK PANEL
HoodTrigger N/A
FactoryAlarmDisarm LT.GRN/ORN(-) DRIVER'S KICK PANEL
ParkingLights BLK/YEL (+) DRIVER'S KICK PANEL
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BRN/YEL (-) AT SWITCH
Tach BLK/GRY (-) (-) AT COIL
SpeedSense WHT/ORN (AC) WIRE HARNESS FROM REAR TRANSAX,2 PIN PLU
ParkingLights BLK/YEL (+) DRIVER'S KICK PANEL
BrakeLights WHT/TAN (+) AT BRAKE SWITCH
ReverseLights VIO/BLK (+) AT SWITCH
Horn BLK/RED (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK (REV) OR PNK/VIO REVERSE POLARITY
PowerLock ORN (REV) OR ORN/VIO DRIVER'S KICK PANEL
LeftFrontWindow01 LF-LTBLU
RightFrontWindow01 RF-BRN/WHT
LeftRearWindow01 LF-WHT
RightRearWindow01 RF-VIO/WHT
Convenience
HeadLights LT GRN(+) (+) HEADLIGHT SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Dimmer ORG/WHT (-) RADIO HARNESS
PowerAntenna YEL (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg GRN/YEL
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg VIOLET/YELLOW
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg BRN/YEL
RearRightSpeakerPos BLU/RED
RearRightSpeakerNeg BLU/WHT
Amp BEHIND LEFT REAR SPK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
