1988 TOYOTA COROLLA 4DR WAGON
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/ORG (+) IGNITION SWITCH HARNESS
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) AT FUSEBOX OR ANTI-THEFT MOD "PASS KICK"
TrunkTrigger RED/WHT (-) (-) AT TRUNK LIGHT "HB WORKS WITH DOME LIGHT
HoodTrigger RED (-) (-) AT ANTI-THEFT MODULE "PASS KICK PANEL"
FactoryAlarmDisarm WHT/GRN (-) AT ANTI-THEFT MODULE "PASS KICK PANEL"
ParkingLights DK.GRN (+) AT FUSEBOX
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/ORG (+) IGNITION SWITCH HARNESS
Ignition02 +
Ignition03 +
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/BLK (-) (-) STEERING COLUMN HARNESS
Tach BLK (-) (-) AT IGNITER OR DIAG PLUG
SpeedSense VIO/WHT (AC) DRIV.SIDE OF CONSOLE ON ECM
ParkingLights DK.GRN (+) AT FUSEBOX
BrakeLights GRN/WHT (+) AT BRAKE SWITCH
Horn GRN/RED (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLU/YEL (-) (-) NEGATIVE TRIGGER
PowerLock BLU/WHT (-) (-) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:YEL
RightFrontWindow01 RF:GRN/RED LR:RED/GRN RR:RED/BLK
LeftRearWindow01 LF:GRN
RightRearWindow01 RF:BLU/WHT LR:BLU/BLK RR:YEL
Convenience
HeadLights RED/WHT (-) (-) AT STEERING COLUMN
LowSpeedWipers BLU/BLK (-) AT STEERING COLUMN
TrunkRelease RED (+) REAR HATCH ONLY
Mobile Audio / Video
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearLeftSpeakerNeg YEL
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
