1988 MAZDA RX-7 2DR CONVERTIBLE
Security
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/GRN + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLU/WHT (-) (-) DRIVER'S PIN SWITCH OR RUNNING BOARD
TrunkTrigger GRN (-) (-) AT TRUNK LIGHT OR THEFT CONTROL UNIT
HoodTrigger BRN/WHT (-) (-) AT THEFT CONTROL UNIT "BEHIND GLOVE BOX"
FactoryAlarmDisarm LT.GRN/BLK(-) AT THEFT CONTROL UNIT "BEHIND GLOVE BOX"
ParkingLights RED/BLK (+) AT LIGHT SWITCH
Remote Start
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/GRN + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach YEL (-) (-) AT IGNITION COIL
ParkingLights RED/BLK (+) AT LIGHT SWITCH
BrakeLights WHT/GRN (+) AT BRAKE SWITCH
ReverseLights RED/GRN (+) AT DRIVER'S KICK
Horn GRN/ORN (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock N/A ADD ACTUATOR IN DRIVER'S DOOR
PowerLock N/A ADD ACTUATOR IN DRIVER'S DOOR
Doorlocks / Windows
Power UnLock
ADD AN ACTUATOR
PowerLock
ADD AN ACTUATOR
Convenience
HeadLights RED/WHT (-) (-) AT LIGHT SWITCH
LowSpeedWipers BLU/RED (-) AT WIPER SWITCH
Mobile Audio / Video
Battery BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination BLU/WHT (+) RADIO HARNESS
Dimmer N/A
PowerAntenna BLU/YEL(-) (-) RADIO HARNESS
FrontLeftSpeakerPos BLU/RED
FrontLeftSpeakerNeg BLU/YEL
FrontRightSpeakerPos BLU
FrontRightSpeakerNeg BLUE/WHITE
RearLeftSpeakerPos BLU/RED
RearLeftSpeakerNeg BLU/GRN
RearRightSpeakerPos BLU/WHT
RearRightSpeakerNeg BLU/GRN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
