1987 FORD MUSTANG 2DR CONVERTIBLE
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) AT PIN SWITCH OR COURTESY LIGHT
TrunkTrigger N/A WORKS WITH DOME LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/LT.GRN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLK/PNK (-) (-) STEERING COLUMN HARNESS
NeutralSafety NOT GROUNDING OEM SWITCH OPENS STARTER CIRCUIT
Tach DK.GRN/YEL(-) (-) AT COIL
SpeedSense GRY/BLK (AC) WIRE HARNESS FROM TRANSMISSION
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights RED/GRN (+) AT BRAKE SWITCH
ReverseLights BLK/PNK (+) (+) AT SWITCH
Doorlocks / Window
PowerUnLock PNK/YEL (REV) REVERSE POLARITY
PowerLock PNK/LT.GRN (REV) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:YEL
RightFrontWindow01 RF:YEL/BLK LR:YEL/LT.BLU RR:YEL/BLK
LeftRearWindow01 LF:WHT/BLK
RightRearWindow01 RF:RED/BLK LR:RED/LT.BLU RR:RED/BLK
Convenience
HeadLights RED/YEL (+) (+) AT LIGHT SWITCH
TrunkRelease VIO/YEL (+) (+) AT TRUNK RELEASE SWITCH
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/LT.GRN + (+) IGNITION SWITCH HARNESS
Ground -
Illumination BLU/RED (+) RADIO HARNESS
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos ORG/GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/GRN
FrontRightSpeakerNeg GREEN/ORANGE
RearLeftSpeakerPos PNK/GRN
RearLeftSpeakerNeg PNK/BLU
RearRightSpeakerPos PNK/BLU
RearRightSpeakerNeg GRN/ORG
Amp BELOW RADIO
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
