1986 MITSUBISHI STARION 2DR COUPE
Security
Battery WHT/BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/GRN (-) (-) AT PIN SWITCH
TrunkTrigger N/A WORKS WITH DOME LIGHT
HoodTrigger N/A
FactoryAlarmDisarm BRN (-) DRIVERS KICK PANEL
ParkingLights GRN/WHT (+) OR RED/WHT AT FUSEBOX
Remote Start
Battery WHT/BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU/BLK + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU/WHT + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense GRN/ORG (-) (-) STEERING COLUMN HARNESS
NeutralSafety LT GRN/BLK (-) GEAR SELECT SWITCH
Tach BLK (-) (-) OR BLU/WHT (-) AT COIL
ParkingLights GRN/WHT (+) OR RED/WHT AT FUSEBOX
BrakeLights GRN (+) AT BRAKE SWITCH
ReverseLights RED/BLU (+) AT GEAR SELECT SWITCH
Horn GRN/BLK (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock RED/BLU (-) (-) NEGATIVE TRIGGER
PowerLock GRN/BLU (-) (-) DRIVER'S KICK PANEL AT DOOR LOCK RELAYS
LeftFrontWindow01 LF:RED/BLU
RightFrontWindow01 RF:RED AT DRIVERS SWITCH
LeftRearWindow01 LF:GRN/BLU
RightRearWindow01 RF:GRN
Convenience
Mobile Audio / Video
Battery WHT/BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLU/WHT + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination BLK/YEL (+) RADIO HARNESS
Dimmer N/A
PowerAntenna WHT/BLK (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLU
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/RED
RearLeftSpeakerPos YEL/BLU
RearLeftSpeakerNeg GRY/BLU
RearRightSpeakerPos YEL/RED
RearRightSpeakerNeg GRY/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
