1983 MITSUBISHI TREDIA 4DR SEDAN
Security
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRN/RED (-) (-) OR YEL/WHT (-) AT PIN SWITCH
TrunkTrigger BLK (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights GRN/WHT (+) OR RED/WHT AT FUSEBOX
Remote Start
Battery BLK + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU/WHT + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense GRN (+) (+) STEERING COLUMN HARNESS
Tach BLK (-) (-) WHT/BLK (-) AT COIL
ParkingLights GRN/WHT (+) OR RED/WHT AT FUSEBOX
BrakeLights GRN (+) AT BRAKE SWITCH
ReverseLights RED/BLU (+) AT GEAR SELECT SWITCH
Horn GRN/BLK (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock BRN/WHT (-) (-) NEGATIVE TRIGGER
PowerLock BRN (-) (-) DRIVER'S KICK PANEL AT DOOR LOCK RELAYS
LeftFrontWindow01 LF:RED/BLU
RightFrontWindow01 RF:GRN LR:RED/YEL RR:BLK DRIVERS SWITCH
LeftRearWindow01 LF:GRN/BLU
RightRearWindow01 RF:RED LR:YEL RR:WHT
Convenience
HeadLights RED (-) (-) AT HEADLIGHT SWITCH
Mobile Audio / Video
Battery BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLU/WHT + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination GRN/WHT (+) RADIO HARNESS
Dimmer N/A
PowerAntenna WHT/BLK (+) RADIO HARNESS
FrontLeftSpeakerPos YEL/BLK
FrontLeftSpeakerNeg RED/BLK
FrontRightSpeakerPos GRN/BLK
FrontRightSpeakerNeg RED/YELLOW
RearLeftSpeakerPos BLK/RED
RearLeftSpeakerNeg RED/BLU
RearRightSpeakerPos BLK/GRN
RearRightSpeakerNeg RED/WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
