1981 FORD MUSTANG 2DR COUPE
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) AT PIN SWITCH OR COURTESY LIGHT
TrunkTrigger N/A
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/LT.GRN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLK/PNK (-) (-) STEERING COLUMN HARNESS
NeutralSafety N/A OEM SWITCH OPENS STARTER CIRCUIT
Tach DK.GRN/YEL(-) (-) AT COIL
SpeedSense GRY/BLK 8000 (AC) WIRE HARNESS FROM TRANSMISSION
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights RED/GRN (+) AT BRAKE SWITCH
ReverseLights BLK/PNK (+) (+) AT SWITCH
Doorlocks / Window
PowerUnLock PNK/YEL (REV) REVERSE POLARITY
PowerLock PNK/LT.GRN (REV) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:YEL
RightFrontWindow01 RF:YEL/BLK
LeftRearWindow01 LF:RED
RightRearWindow01 RF:RED/BLK
Convenience
HeadLights RED/YEL (+) (+) AT LIGHT SWITCH
TrunkRelease VIO/YEL (+) (+) AT TRUNK RELEASE SWITCH
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/LT.GRN + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination BLU/BRN (+) RADIO HARNESS
Dimmer N/A
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg BLK/WHT
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/WHITE
RearLeftSpeakerPos PNK/RED
RearLeftSpeakerNeg PNK/BLU
RearRightSpeakerPos PNK/BLU
RearRightSpeakerNeg GRN/RED
Amp UNDER CENTER OF DASH
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
